HEAD LAMP RELAY INSPECTION
| 1. |
Pull out the head lamp relay (Low) (A) and
head lamp relay (High) (B) from the engine compartment relay
box.
|
| 2. |
Check for continuity between terminals. There
should be continuity between the No.87 and No.30 terminals when
power and ground are connected to the No.86 and No.85
terminals. |
| 3. |
There should be no continuity between the
No.87 and No.30 terminals when power is disconnected.
|
HEAD LAMP AIMING INSTRUCTIONS
The head lamps should be
aimed with the proper beam-setting equipment, and in accordance with the
equipment manufacturer's instructions.
|
If there are any regulations pertinent to the
aiming of head lamps in the area where the vehicle is to be used,
adjust so as to meet those
requirements. |
Alternately turn the
adjusting gear to adjust the head lamp aiming. If beam-setting equipment
is not available, proceed as follows :
| 1. |
Inflate the tires to the specified pressure
and remove any loads from the vehicle except the driver, spare tire,
and tools. |
| 2. |
The vehicle should be placed on a flat
floor. |
| 3. |
Draw vertical lines (Vertical lines passing
through respective head lamp centers) and a horizontal line
(Horizontal line passing through center of head lamps) on the
screen. |
| 4. |
With the head lamp and battery in normal
condition, aim the head lamps so the brightest portion falls on the
vertical lines.
Make vertical adjustments to the lower beam
using the adjusting wheel.
|
FRONT FOG LAMP AIMING
The front fog lamps
should be aimed as the same manner of the head lamps aiming.
With the front fog lamps
and battery normal condition, aim the front fog lamps by turning the
adjusting gear (A).
HEAD LAMP AND FOG LAMP AIMING POINT
| 1. |
Turn the low beam on with driver.
The cut-off line should be projected in the W1
range.
In case of equipping with the manual leveling
device, set the leveling device switch on the "O"
position.
* In case of high beam, head lamp do not need
aiming with proper beam-setting
equipment. |
| 2. |
Turn the front fog lamp on with
driver.
The cut-off line should be projected in the
allowable range (shaded region)
|
| 1. |
Disconnect the negative (-) battery
terminal. |
| 2. |
Loosen the mounting bolts and a nut of head
lamp. Remove the head lamp assembly(A) after disconnecting the lamp
connectors.
|
| 3. |
Remove the head lamp bulb after removing the
bulb caps(A).
|
| 1. |
Install the head lamp
bulbs. |
| 2. |
Reassemble the head lamp bulb
caps. |
| 3. |
Reassemble the head assembly after connecting
the lamp
connector. |
