VERACRUZ(EN) >2008 > G 3.8 DOHC > Body Electrical System > Windshield Wiper/Washer > Windshield Wiper-Washer Switch>Repair procedures  
REMOVAL
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (B) after removing 3 screws and connector(A).

3.
Remove the wiper switch assembly after disconnecting the front and rear wiper/washer switch connectors and loosening 2 screws.

INSTALLATION
1.
Connect the connectors and reassemble the wiper switch assembly.
2.
Reassemble the steering column upper and lower shrouds.
INSPECTION

FRONT WIPER WASHER
Check for continuity between the terminals.
1.
There should be continuity between the No.1 and No.10 terminals when power and ground are connected to the No.1 and No.7 in the ICM-A.
2.
There should be no continuity between the No.1 and No.10 terminals when power is disconnected.
FRONT WIPER
Check for continuity between the terminals.
1.
There should be continuity between the No.2 and No.3 terminals when power and ground are connected to the No.1 and No.9 terminals in the ICM-A.
2.
There should be no continuity between the No.2 and No.3 terminals when power is disconnected.
INSPECTION

FRONT WIPER WASHER
Check for continuity between the terminals.
1.
There should be continuity between the No.1 and No.10 terminals when power and ground are connected to the No.1 and No.7 in the ICM-A.
2.
There should be no continuity between the No.1 and No.10 terminals when power is disconnected.
FRONT WIPER
Check for continuity between the terminals.
1.
There should be continuity between the No.2 and No.3 terminals when power and ground are connected to the No.1 and No.9 terminals in the ICM-A.
2.
There should be no continuity between the No.2 and No.3 terminals when power is disconnected.