Inspection

1.	With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.

2.	Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.

3.	Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.

4.	If they are abnormal, replace the washer motor. [Front & Rear washer] 1. Ground 2. Windshield washer (+) 3. Rear washer (+)

1.	Disconnect the negative(-) battery terminal.

2.	Drain the washer fluid less than 950 cc.

3.	Check for continuity between the No. 1 and No.2 terminal in each float position. There should be continuity when the float is down. There should be no continity when the folat is up.

4.	If the continuity is not as specified, replace the washer fluid level switch

Removal

- When servicing the washer pump, be careful not to damage the washer pump seal. - Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body group - Front bumper)

3.	Remove the washer hose and the washer motor connector(A).

4.	Disconnect the washer fluid level sensor switch connector (A).

5.	Remove the washer reservoir after removing 3 bolts.

Installation

1.	Reassemble the washer reservoir. Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.

2.	Connect the washer motor connector and washer hose.

3.	Reassemble the front bumper cover.