| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the lower anchor
bolt. |
| 3. |
Remove the door scuff trim. (Refer to BD
group) |
| 4. |
Remove the center pillar trim. (Refer to BD
group) |
| 5. |
Remove the upper anchor
bolt. |
| 6. |
Disconnect the Seat Belt Pretensioner
connector.
|
| 7. |
Loosen the Seat Belt Pretensioner mounting
bolt and remove the Seat Belt Pretensioner.
|
| 1. |
Remove the ignition key from the
vehicle. |
| 2. |
Disconnect the battery negative cable and wait
for at least three minutes. |
| 3. |
Install the Seat Belt Pretensioner (BPT) with
a bolt. |
| 4. |
Install the upper anchor bolts.
Tightening
torque (Seat Belt Anchor Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9
~ 39.8 lb.ft)
| |
| 5. |
Connect the Seat Belt Pretensioner (BPT)
connector. |
| 6. |
Install the center pillar
trim. |
| 7. |
Install the door scuff
trim. |
| 8. |
Install the lower anchor bolts.
Tightening
torque
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9
~ 39.8 lb.ft)
| |
| 9. |
Reconnect the battery negative
cable. |
| 10. |
After installing the Seat Belt Pretensioner
(BPT), confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
