| Pressure Side
Impact Sensor |
| •
|
Removal of the airbag must be
performed according to the precautions/procedures described
previously. |
| •
|
Before disconnecting the side impact
sensor connector(s), disconnect the side airbag
connector(s). |
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the side
impact sensor.
| |
| 1. |
Disconnect the battery negative cable, and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the front door trim.
(Refer to the Body group - "Front
door") |
| 3. |
Disconnect the pressure side impact sensor
connector and remove the pressure side impact sensor mounting
screws.
|
Rear
Side Impact Sensor
| 1. |
Disconnect the battery negative cable and
wait for at least three minutes before beginning
work. |
| 2. |
Remove the rear seat.
(Refer to the Body group -
"Seat") |
| 3. |
Remove the luggage side trim.
(Refer to the Body group - "Interior
trim") |
| 4. |
Disconnect the rear side impact sensor
connector. |
| 5. |
Loosen the rear side impact sensor mounting
bolt and remove the rear side impact sensor.
|
| Pressure Side
Impact Sensor |
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the side
impact sensor.
| |
| 1. |
Install the new pressure side impact sensor
with the screws then connect the SRS harness connector to the
pressure side impact sensor.
Tightening
torque
: 5 ~ 7 N.m (0.5 ~ 0.7 kgf.m, 3.7 ~
5.2 lb-ft)
| |
| 2. |
Install the front door trim.
(Refer to the Body group - "Front
door") |
| 3. |
Reconnect the battery negative
cable. |
| 4. |
After installing the front side impact
sensor, confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go off. |
| • |
Failure to torque the bolts to
specification can cause the sensor (FSIS, P-SIS) to
break or the nut setter insert to
spin. |
| • |
Problems may occur with the
inpact sensor pertormance if the nut insert is
spinning. |
| • |
The door seal must not be
damaged and must remain sealed. The SRSCM monitors the
pressure sensor in the door module to indicate an
impact. | | |
Rear
Side Impact Sensor
| •
|
Do not turn the ignition switch ON and
do not connect the battery cable while replacing the side
impact sensor.
| |
| 1. |
Install the new side impact sensor with the
bolt then connect the SRS harness connector to the side impact
sensor.
Tightening
torque
: 6.8 ~ 9.2 N.m (0.7 ~ 0.9 kgf.m, 5.0
~ 6.8 lb-ft)
| |
| 2. |
Install the luggage side trim.
(Refer to the Body group - "Interior
trim") |
| 3. |
Install the rear seat.
(Refer to the Body group -
"Seat") |
| 4. |
Reconnect the battery negative
cable. |
| 5. |
After installing the Side Impact Sensor,
confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS
indicator light should be turned on for about six seconds and
then go
off. | | |
